3/26/2023 0 Comments Hover jets![]() ![]() When the hover percentage is greater than 0% the aircraft will go up, when it is less than 0% the aircraft will go down the larger the percentage number the more rapidly the aircraft will move up or down. Pressing the increase/decrease key will increase or decrease the hover percentage (it will stay at whatever value it is at while no keys are pressed). If relative control is enabled then hover mode becomes a scale between -100% and +100%, with a value of 0% meaning the aircraft stays at its current altitude. If relative control is disabled then pressing the increase key will make the aircraft go up until the key is released, at which point the aircraft will stabilise at whatever altitude the key was released at. ![]() All other options are personal preference you will need to make a decision about whether to use relative control or not. Like "Thrust Vector" it is an axis control and is set up in a similar way bind the increase option to the key you want to make your aircraft go up, and decrease option to the key to make your aircraft go down. The "Hover height" control is used to increase and decrease your height when in hover mode. The "Hover mode" control puts the aircraft in and out of hover mode you can bind it to any key you want, however hover mode is of limited use so leaving it unbound is fine. It is vital that you enable relative control for this option or else it will not work properly, all other settings (sensitivity etc.) are up to personal choice and can be left at default. makes the nozzles point down), while "Decrease values" does the reverse. Increase value increases the thrust vector amount (i.e. Assuming you are binding to a key/mouse button (rather than something like a joystick or throttle lever) you will want to bind the "Increase value" and "Decrease value" options to your desired keys. In order to bind this control, find it in the controls list and select "Edit Axis", you will then be presented with quite a few options. has an increase key, a decrease key, and various options associated with it) and controls what angle the thrust vectoring nozzles are pointed/what power setting the lift engines run at. The core control for VTOL aircraft is "Thrust Vector", this is an axis control (i.e. Make sure you enable relative control on the "Thrust Vector" axis control, or VTOL will not work properly Ensure relative control is turned on.Īxis control - Increases or decreases the hover height. A description of the controls and how to set them up can be seen below.Īxis control - Increases or decreases the angle of the thrust vectoring nozzles. There are only a few controls specifically associated with VTOL aircraft. VTOL aircraft can hover, take off, and land vertically. Vertical Take-Off and Landing (VTOL) is a design feature found on some aircraft in the game. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |